BTU Heat Exchanger

A heat exchangers are the most cost effective method of controlling the water temperature of Ponds.

Using a heat exchanger provides a method of heating water by simply pumping the water, on it’s return to the pond in much the same you would connect a UV steriliser.

Water enters through the Inlet Pipe and then circulates past an inner Stainless Steel Coil.

The coil contains hot water from the boiler.

The heat from the ‘Hot Water’ in the inner coil never makes contact with the actual pond water but the heat generated from it is then transferred to the water flowing round it by radiation providing heat to your pond.

All our heat exchangers are made from the finest quality 316 Stainless Steel and have a superb finish.

All units must be installed vertically.

Care must be taken to insure that no chemical residue can enter the heat exchanger when the system is not running.

It is recommended to maintain a constant pH between 7.2 & 7.6 to prevent excessive scaling deposits and corrosion.

It is paramount that the unit is installed in an upright position; with the primary and flow connections from the boiler set top and bottom.

The secondary flow, which is the heated flow to the pond (usually after filtration), is then connected to the top right and the flow though which transfers the heated water to the pool will be situated at the lower left outlet.

All threaded connections are standard BSP thread.

The connections on the heat exchanger are – pond water inlet & outlet 1½” Male Thread – Boiler inlet & outlet 1″ Male Thread (Not Supplied)